Toyota 2JZ-GTE 12 Injector Port Casted Aluminum Intake Manifold
Ready for shipping
After a few month of computer design and simulations, the result was a well balanced manifold between performance and looks. We are proud to announce that it was 100% tract tested with 0% failure. And it has met and exceeded all our expectation. Our formula is very simple, proper CFM with minimum air turbulence and high air velocity = horse power and torque.
This manifold is sand casted out of 356 aluminum and heat treated to T6 for superior strength. Designed for extreme boost application like 100+ psi. It is available in your choice of 6 or 12 injector ports, using an aluminum extruded high flow -10 fuel rail. The plenum has a 105 mm inlet opening with an over size throttle body bolt pattern. It comes with your choice of a 100 or 105 mm Pro-Jay low profile throttle body.
Intake Features:
- Easy set-up
- Large double taper plenum designed to lower air turbulence
- tapered runners designed to increase air velocity
- Large 105mm inlet for higher CFM
- A-356 heat treated aluminum casting for extreme high boost
- Your choice of 100mm or 105mm Pro-Jay low profile throttle body
- Throttle cable bracket
- Large o-ring between manifold and throttle body
- black wrinkle powder coat finish
- Extruded aluminum high flow -10 fuel rails
Throttle Body Features;
- 105 mm Pro-Jay Low Profile Mustang Throttle Body
- Over size Stainless Steel Shaft
- 1/8" Thick Brass Butterfly with double Edge like a Knives, front and back for better Air Flow
- Over size Stainless Steel Shaft
- Cable Bracket
- Adjustable Linkage
- Large O-Ring in front and Back of Throttle Body
- V-Band with V-Clamp
- Using 1986-1993 Ford Mustang 5.0l TPS ( SOLD SEPARATELY )